Through the Wall Air Conditioners, Ask us about High Reach Bucket Truck Installations.
When buying a new through-the-wall air conditioner, look for units with an EER of 10.0 or above. Check the Energy Guide label for the unit, and also look for room air conditioners with the ENERGY STARŪ label. Thru-wall Air Conditioning Contractors, residential & commercial, thru-wall air conditioning installation, thru-wall air conditioning units, HVAC, duct cleaning, heating pumps, cooling. |
GET Knowledge & Know-How from Experts Near You @ Able Group .net
We're the most informative team of experts for Property Trade Workers in our area. |
 |
 Contact Us About the Alternatives!
<
Sanyo developed a "Ductless Split System" air conditioner in 1961. They have since been joined by Mitsubishi, Samsung and Multi-Aqua. These systems are ideal in situations where zoned cooling is desired, or where running ductwork is not possible. In a Sanyo Ductless Split System, the Freon condenser is mounted outdoors. The indoor units (evaporators) are mounted on a wall or the ceiling in each of the rooms to be cooled. They are connected to the condenser by small copper tubes which easily fit through most wall cavities.
Through the Wall Air conditioners, High Reach Installers all around Philly and NJ Shore Points.
Jersey Shore Workers for Thru-Wall Air Conditioners.
|
And We install them anywhere!
   
We specialize in Thru-Wall Air Conditioners.
Step One, Call us about air conditioning especially call us about brick cut installations. HVAC, heat pump, split system, and energy efficient installation, ductless AC, ventilation, cooling fans, thermostat, ductwork, window unit air conditioner and who to call for an electrician or an electrical contractor.
Step Two, Measure the hole in the dimension needed according to the air conditioner's installation directions. Mark the dimensions on the wall.  Carefully cut away the drywall under the window. Use the pry bar to carefully remove the drywall. Set it aside.
Step Three, Build the frame for the air conditioner unit under the window. Make sure the measurements are correct for the unit you are installing. Use 2x4 or 2x6 lumber according to the width of your house's exterior wall. Step Four, Open the exterior wall. Drill a hole on the inside corner of the frame from the interior of the house out. These four holes mark where to cut on the exterior wall. Draw four straight lines on the outside of the house to mark where to cut. Use your saber saw or circular saw to cut away the exterior section. Step Five, Slide the air conditioner chassis into place. Make sure the air conditioner has a slight tilt so the condensation runs outside. Attach to the walls according to the manufacturer's directions. Slide the air conditioner into place and secure it. Step Six, Replace insulation around the air conditioner unit. Use the drywall that you took out earlier to cover any portions of the wall that may be exposed. Seal the seams with drywall tape. Step Seven, Caulk around the outside of the air conditioner unit.
Silicone is a good choice because it is flexible in all kinds of weather and can withstand the vibrations of the air conditioner. Step Eight, Call Us About the cost for anything else you'd rather not do; evaporator, coil, rooftop units, etc. Caulking silicone sealing joints of various materials labor per hour |
|
We can install a window unit air conditioner through the wall including cut brick and re-seal. Serving areas surrounding; Delaware County, Philly, Philadelphia, PA, South Jersey, Brigantine, Atlantic City, Ventnor, Margate and Ocean City NJ. Call us for Exterior Wall Openings a Job Done Right !
It's all about how you do the Work. 
Basement Water Pump Sys.
Driveway Heaters
Electric Snow Melting for Sidewalks
Fence for Electrical Equip.
Generators, Commercial, Industrial
Snow Melting Systems
Sump Pumps - PRICE LIST |
The Original Property Information Network - Over 25 Years. 
.
.